70 Series Fishing Rod Holder - 30-Degree Flush Mount - Cast Bottom w/ Drain - 1-5/8 ID CE Smith Fishing Rod Holders CE53672CA

CE Smith Flush Mount Cast Bottom 30-Degree Rod Holder

Backing Plate for 70 Series Rod Holders Backing plates are very important to have under every rod holder used for heavy tackle fishing. When the rod holder is under extreme load, regular nuts and washers can concentrate stress and cause spider cracking around your rod holders, or perhaps even tear through, causing severe gunnel damage. Smith backing plates distribute mounting bolt pressure evenly over 30 times more surface area than with standard washers alone.

C E Smith Backing Plate F 70 Series Rod Holders

70 Series Fishing Rod Holder - Flush Mount - Open Bottom - 1-5/8

SMITH 70 Series Flush Mount Rod Holder - Screwless - Cast Bottom Screwless installation provides flush high end look on gunnel of your boat. 70 series flush mount rod holders come in 0, 15, and 30 degree with black liner. Made from 316L stainless steel. 1-5/8 inner diameter and 2-1/8 outer diameter with a total tube length of 9. Includes backing plate and installation nut.

C.E. Smith 70 Series Flush Mount Rod Holder - Screwless 0 Degrees

30 Degree Flush Mount With Bar Bottom; Holds Single Spinning or Casting or Conventional Fishing Rod;

CE SMITH CE Smith Flush Mount Rod Holder - 30 Degree / 53672A /

70 Series Fishing Rod Holder - 30-Degree Flush Mount - Cast Bottom

70 Series Fishing Rod Holder - 15-Degree Flush Mount - Cast Bottom

C.E. SMITH C.E. Smith Flush Mount Rod Holder - 30

CE Smith Standard-Duty, 0 Degree Flush Mount Rod

CE Smith Flush Mount Cast Bottom 30-Degree Rod Holder